How to fix a nail clipper

If the nail clippers are rusted, dull, or damaged, Esha Ltd. suggests that the following methods can be tried to fix them:

1. Remove rust: You can use vinegar, lemon juice, white wine, etc. to apply to the rust, then gently brush with a soft brush, and finally dry with a dry cloth.

2. Sharpening: You can use a whetstone or fine sandpaper to sharpen the nail clippers, paying attention to keeping the angle consistent to avoid deformation of the knife edge.

3. Adjust the tightness: If the nail clipper is loose or too tight, you can use a wrench or pliers to adjust the tightness, but be careful not to use excessive force to avoid damaging the nail clipper.

4. Replacement parts: If the nail clipper is seriously damaged and you need to replace the parts, you can disassemble the nail clipper and purchase the corresponding parts for replacement.

In short, repairing nail clippers needs to be determined on a case-by-case basis, and if it cannot be repaired by itself, it is recommended to buy it again or send it to a professional repair shop for processing. At the same time, in order to maintain the good condition of the nail clippers, it is necessary to clean and maintain them in time after usual use.